SparkFun PIR Motion Sensor (JST) Proximity Support Equipment Enables you to shoot towards

Enables you to shoot towards the light source

32-bit unique ID - non-reprogrammable

2x15W is driven into a 8 BTL load (TPA3130D2)

Extends to 108 cm

1" spacing allowing it to be inserted into development boards and perf boards with mild modification

SparkFun PIR Motion Sensor (JST) Proximity Support Equipment Enables you to shoot towardsThis is a simple to use motion sensor. Power it up and wait 1 2 seconds for the sensor to get a snapshot of the still room. If anything moves after that period, the alarm pin will go low. This unit works great from 5 to 12V (datasheet shows 12V). You can also install a jumper wire past the 5V regulator on board to make this unit work at 3. 3V. Sensor uses 1. 6mA@3. 3V. The alarm pin is an open collector meaning you will need a pull up resistor on the